FX DOCUWIDE 6050 DRIVER

This is followed by operation. Unlike during printing, no information on paper is provided at warm up. Fuser gets ready to receive a print. Looking for a tech bargain real soon? You should take care of the key to your lodging room. By detecting the background levels of the small separate areas, the scanner can sufficiently deal with a document whose background density is uneven due to exposure to sunlight or discoloration. When paper becomes low and Tray Face Control Sensor does not sense any more paper sheet, another stack of paper is lifted until the face of the top sheet reaches the Nudger Roll position in the same manner as the stack is after paper size sensing.

Uploader: Meztishicage
Date Added: 3 June 2010
File Size: 28.73 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 52071
Price: Free* [*Free Regsitration Required]

The range available for selection is 0 to 50, which is equivalent to 0 to 5mm. The scanner that detects background levels in processing a line, etc. To be rotated at output, stamp data is temporarily decompressed into the work buffer, where the stamp data is rotated 0 degree, 90 degrees, docwide and deg rees and then compressed again.

Toner Waste Bottle Full Error is not cleared until the power is turned off. However, if the cut operation is initiated while the inter-image is being secured, after an elapse of the time obtained by the expression: The counter is set to count one docuwjde one meter.

  MSI VR630 MS-1672 DRIVER

Figure is a simple graphic representation of density levels of a certain scan position P on a scanned document. The adjustment of image length for exposure leads to the erase of the trail edge.

Rubbish Bed Sheet You should remove a bed sheet and a pillow cover and put them out in front of your room door on the focuwide day. When the data reaches 1 m, the counter will count up one more.

DocuWide 6050 Drivers & Downloads

The parameters for calculating a temperature are therefore as follows: During print, count-up information is sent every time IOT outputs a print successfully. The lead edge of roll paper is cut mm as a margin for preventing the 1st Copy Deletion.

Cleaning Blade is always in contact with the Drum. You are not allowed to smoke while walking, in the classroom and training room. The main functions of Chain 6 are as follows: Auto loading from the rear roll is performed first, followed by that from the front roll. To prevent impulsive sound in closing Swing Baffle, the following operation is performed.

Xerox DocuWide MF – multifunction printer (B/W) Overview – CNET

There is no light quantity control, etc. B The requirement for shifting to Sleep Mode is that a specifically set time Default: There are two types of power save modes: A block letter is supported.

  ACPI TOS6205 DRIVER DOWNLOAD

Initializes the network board. Toner is therefore drawn to the Drum though being repulsed by the negative charge. Hollywood racked up an The 1st day 9: Screen patterns for color conversion are decompressed from HDD into the screen tone memory.

The trail edge is sensed by Registration Sensor. Plain paper, tracing paper and film can be set. Actually an image of dots can be prohibited from being output because the output of image data in steps of 8 dots is prohibited. The timing for sensing paper width is prefeed end.

On the other hand, when any of the requirements for clearing Power Save Mode is satisfied, it makes IOT ready to print. LPH emits light rays over the negatively charged Drum to generate an electrostatic latent image on the Drum surface.

In this case, the following, and are not performed. Smoking is allowed in only the palce s equipped with ashtrays.