ELLIX 10 DRIVER

Be sure to use paper rolls that meet the specifications. Run any software program that sends data to the printer. Insert the paper roll as shown. Push the open button and open the cover open. Kansaki Specialty Papers, Inc.

Uploader: Tojalkis
Date Added: 23 October 2008
File Size: 40.89 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 3534
Price: Free* [*Free Regsitration Required]

You must be logged in to post a review. Then close the cover.

PRINTER, SAM4S ELLIX 10

Be sure elllx to connect the external power supply with the wrong polarity. New Oji Paper Mfg, Co. It does, however, offer some settings for users with special requirements. Delivery timeframes depend on the delivery location and might take longer in the case of remote or rural areas.

If the power supply voltage drops to the outside of the range above during printing, the printer stops printing and waits until the voltage returns to normal and then automatically begins printing again.

It has DIP switches that allow you to change communication settings, such as handshaking and parity check, as well as printing density. They all connect to the connector panel on the back of the printer, which is shown as below: This equipment generates uses, and can radiate radio frequency energy andif not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

  FUJITSU FI-6130ZDJ TWAIN DRIVER

elllix

Ellix | Central Cash Register

Tighten the screws on both sides of the cable connector. Ellid accuracy of the Near-End sensor depends on the adjustment scale setting and the winding core diameter of the roll paper. The printer prints a pattern using the 6. The first column contains the hexadecimal codes and the second column gives the ASCII characters that correspond to the codes.

If you find that there is not enough paper remaining on the roll when the near-end detector is triggered, you can change the near-end sensor setting. If any items are damaged or missing, please ellux your dealer for assistance.

SAM4S ELLIX Thermal POS Printer Series

Using an incorrect power supply may cause fire or electrical shock. Eellix the setting to the scale 1,2,3,4 and 5. Also, be sure to turn off the printer power before cleaning the printer head. This equipment has been tested and founded to comply with the limits for a Class A digital device pursuant to Part 15 of the FCC Rules.

Before connecting any cables, make sure that both the printer and the computer should be turned off. Download Brochure Download Specifications.

  HEWLETT PACKARD 3564 DRIVER

Do not touch the print head thermal elements. Close the Cover Wire. The Near-End sensor is set at adjustment 3. For more information, please contact our customer service. Setting Up the Printer If you find that there is too much paper remaining on the roll paper when the Near-End sensor is triggered. Make sure that you use the attached Power supply or equivalent.

Run any software program that sends elpix to the printer. Kansaki Specialty Papers, Inc. Open sllix paper roll cover, remove the jammed paper, and reinstall the paper roll.

Printing speed may be slower, depending on the data transmission speed and the combination of control commands. Low noise thermal printing.

This is the appropriate scale for the recommended paper thickness. The socket-outlet shall be near the equipment and it shall be easily accessible. You can also hold down the FEED button to feed paper continuously.